How to install the interactive whiteboard?
How should we install it after we buy the interactive smart whiteboard? If you can use this time to read this article, you can save a lot of energy and time, because we can complete the installation of the interactive whiteboard in 20 minutes.
Wall-mounted install
Step 1: Before wall-mounted installation, please place the smart board horizontally on a flat surface (with the screen facing down), and there must be soft objects (such as rubber pads, cotton cloth, foam, etc.) between the device and the surface to avoid bumps on the surface of the device .
Step 2: Before installing the wall mount, please carefully check the specifications and quantities of the wall mount components and the fasteners in the accessory bag to ensure that they are correct.
Step 3: Fasten the arms of the two wall-mounted brackets with 4PCS screws C. To ensure the stability and safety of the interactive whiteboard, it is strictly forbidden to hang the device upside down. If the wall mount is already installed on the whole machine, ignore this step.
Step 4: Select a solid wall or concrete wall that can meet the requirements of equipment suspension. It is recommended to use a 12mm impact drill to drill holes according to the position in the above picture and the distance in the table below. The depth of the hole should be greater than the length of the expansion rubber plug and the thickness of the wall surface coating. and. Use a hammer to completely drive the expansion rubber plug d into the non-coated wall. If the rubber plug is not fastened after nailing, it is necessary to replace the appropriate impact drill bit and re-select the position for drilling.
Step 5: Use the combination of 8PCS screw f and washer e to fix the wall-mounted board a on the 8PCS expansion rubber plug.
Step 6: Fix the interactive panel horizontally and vertically on the wall-mounted board through the hanging arm.