How to take waterproof measures for outdoor advertising machine
How to take waterproof measures for outdoor advertising machine
To put it bluntly, the outdoor advertising machine is a convenient LCD advertising machine used outdoors, and the outdoor conditions are relatively weak. For example, hot weather. It is cold in winter. The impact of extreme weather such as wind, rain, and snow from time to time, the outdoor advertising machine will not work if the protection work in these areas is not done well, so how should the outdoor advertising machine do a good job of waterproofing? Below, we will give you a specific detailed introduction, the main contents are as follows:
1. Add backplane sealant.
For convenience, many partners will not add a backplane or a sealant on the backplane when installing the outdoor advertising machine. In this way, as time goes by, electronic components will inevitably enter the water, and as time goes by, outdoor digital signage will have problems. Electronic components are most afraid of water. Once the water gets into the line, it ignites the irritating line. This manageable problem cannot be ignored.
2. Open the water outlet.
If the outdoor electronic signs is connected to the gap on the back panel, be sure to make a leak on the bottom; the leak is used for water leakage. No matter how closely the front, rear, left, and right connections of the outdoor advertising machine are, there is more or less water inside. If there is no leak hole in the lower hole, more and more water will accumulate as time goes by. If the water hole is opened, the water will flow out, which can bring a good waterproof and presoaking effect, which is beneficial to prolong the service life of the outdoor advertising machine.
3. Appropriate route.
When installing an outdoor digital signage, you must choose a suitable wire for the plug connection. Generally, it follows the standard of Ning Da. Even if the total output power of the outdoor advertising machine is good, choose a slightly larger wire, try not to choose a suitable or too small wire, it is very easy It will cause damage to the route and endanger the reliable operation of the outdoor lcd display